Charger for Mobility Scooters and
Wheelchairs with 3 Pin XLR Connector
24 VOLT - 5 AMP: Fully Automatic
two-stage battery charger, UL and CSA approved, Dual Mode (for
gel/sealed and wet batteries). Specially designed for Industrial
and OEM applications such as Mobility aids, wheelchairs, scooters
and electric bicycles among others.
Selectable charge mode:
A switch permits the user to select the type of charge required for
either Gel or Wet Lead-acid. These voltage settings are identified
above in the output ratings.
Full 3 LED Display:
Indicators display the battery's condition. As a battery reaches
full charge, the yellow and green lights will flash alternately.
This automatic cycling of the charger prevents overcharging, as the
battery reaches its full capacity. Once fully charged the charger
will continue to cycle with yellow and green lights flashing
alternately, keeping the battery at its peak
- Red Light: Indicates the
charger is properly connected to 120V supply.
- Yellow Light: Indicates
correct polarity and combined with red light indicates charger is
- Green Light: Indicates a
full charge. Green and yellow will flash alternately when battery
has reached a full charge (The yellow light will flash on about
every 10 seconds)
Protection: The charger
has electronic protection against reverse polarity and short
circuits. The overload protection is provided by two fully
automatic re-settable bimetallic circuit breakers. One protecting
against excess current flow and the other from excess temperature
Charging: The charger
is capable of charging all commonly available Lead Acid batteries
with ratings from 20 to +100 Ah. All functions are fully automatic
and the charger constantly monitors the battery’s condition. The
charging sequence is determined by the condition of the battery and
is fully interactive.
Battery Recovery: (deep
discharge pick-up) The charger is capable of fully and properly
recharging any battery discharged down to 10 Volts. Even a totally
discharged battery will recover to 20 Volts in 10 to 60 minutes,
when the load is removed.
No risk of shock:
Charger case is made from advanced engineering plastic. Due to its
double insulation, a grounding pin is not required and hence the
input connector has only two pins (we have an international
standards approval on this model).
- OUTPUT: 25 Volt Nominal; 5 Amp
- Set Voltage: Gel: 28.6 +/- 0.2 WET
LEAD ACID: 29.9 +/-0.2
- Float Voltage: 27.2 +/- 0.2 28.8
- INPUT: 105 VAC - 120 VAC ; 60
- DIMENSIONS: 6" wide x 11" high x 4"
- 15cm x 27.5cm x 10cm
- WEIGHT: 9 lbs.; 4.09kg
- 1 Year Warranty
*^*SLA Charging 1 Year warranty to gaurantee against manufacturing defects 149.99 any SLA Battery